Replacing a Washing Machine Drain Pump
A washing machine drain pump is an essential component of your washing machine that helps to pump water out of the machine during the wash cycle. Over time, the drain pump may become damaged or worn out, resulting in poor drainage or water leakage.
If this happens, it is important to replace the drain pump as soon as possible to avoid further damage to your machine. In this article, we will provide you with a step-by-step guide on how to remove and replace a washing machine drain pump.
Before we begin…
- Disconnect the appliance from any power supply and isolate the supply so it cannot be accidentally reconnected while you are working on it.
- Wear gloves! While appliances are nice and smooth on the exterior and pose no risk to cuts etc, the inside of appliances can be extremely sharp as they are not designed for consumers hands to be inside the machine.
- If you are not confident in attempting any repair to a domestic appliance, then call an expert.
Materials needed:
- Replacement Washing Machine Drain Pump
- Pliers
- Screwdriver (Phillips and flathead)
- Towels or a bucket to catch water
Instructions:
- Locate the drain pump – The drain pump is usually located at the bottom of the washing machine, either at the front or the back. To locate it, you may need to tilt the machine or remove the back panel.
- Remove the drain hose –The drain hose is the hose that connects the drain pump to the drainage system. To remove it, use pliers to loosen the clamp that secures it in place, and then pull the hose out of the pump.
- Remove the electrical connections – The drain pump is also connected to the washing machine by electrical wires. Use a screwdriver to loosen the screws that hold the wires in place, and then pull the wires out of the pump.
- Remove the drain pump – The drain pump is held in place by mounting screws. Use a screwdriver to remove the screws and then gently pull the pump out of the machine.
- Install the new drain pump – Position the new drain pump in the same place where the old pump was and secure it in place with the mounting screws. Make sure that the pump is properly aligned and tightly secured.
- Reconnect the electrical connections – Attach the electrical wires to the new drain pump using the screws that you removed earlier. Make sure that the connections are secure and tight.
- Reattach the drain hose – Slide the drain hose back into place on the new pump and use pliers to tighten the clamp.
- Test the new drain pump – Fill the washing machine with water and run a short cycle to test the new drain pump. Check for any leaks or unusual noises. If everything seems to be working correctly, you can now reattach the back panel (if you removed it earlier) and plug the machine back into the power outlet.
In conclusion, replacing a washing machine drain pump is a straightforward process that can be completed with a few basic tools and some careful attention to detail.
By following these steps, you should be able to successfully remove and replace a faulty drain pump, helping to restore your washing machine to its full functionality.
Shop a wide range of Washing Machine Spares at Whitegoods Help!
