Replacing a Dishwasher Drain Pump
Replacing a dishwasher drain pump can seem like a daunting task, but with the right tools and some basic knowledge, it can be a straightforward process.
In this article, we’ll go through the steps involved in removing and replacing a dishwasher drain pump.
Before we begin…
- Disconnect the appliance from any power supply and isolate the supply so it cannot be accidentally reconnected while you are working on it.
- Wear gloves! While appliances are nice and smooth on the exterior and pose no risk to cuts etc, the inside of appliances can be extremely sharp as they are not designed for consumers hands to be inside the machine.
- If you are not confident in attempting any repair to a domestic appliance, then call an expert.
Materials needed:
- Replacement Dishwasher Drain Pump
- Screwdriver (Phillips and Flathead)
- Pliers
- Towels
Instructions:
- Remove the Dishwasher – The first step is to remove the dishwasher from its place. Turn off the water supply and unplug the dishwasher from the wall outlet. Once it’s unplugged, slide the dishwasher out from under the countertop and onto the floor. You may need to ask someone for assistance if the dishwasher is heavy.
- Locate the Drain Pump – Once the dishwasher is out, locate the drain pump. The pump is usually found at the bottom of the dishwasher and is connected to the drain hose. The pump is secured to the dishwasher with a few screws.
- Remove the Old Drain Pump – To remove the old drain pump, first, disconnect the wires connected to the pump. Use a pair of pliers to loosen the hose clamps that connect the drain pump to the dishwasher. You may need to use a towel to catch any water that spills out during this process. Next, remove the screws that secure the pump to the dishwasher. Once the screws are removed, gently pull the pump out of the dishwasher.
- Install the New Drain Pump – With the old pump removed, it’s time to install the new drain pump. Start by attaching the new pump to the dishwasher with screws, making sure it’s firmly in place. Reconnect the drain hose and secure it with the hose clamps. Finally, reconnect the wires to the new drain pump, ensuring they are correctly connected.
- Test the New Drain Pump – Before putting the dishwasher back in place, test the new drain pump to ensure it’s working correctly. Turn on the water supply and plug in the dishwasher. Run a short cycle and check for any leaks or unusual sounds. If everything is working correctly, you’re ready to put the dishwasher back under the countertop.
- Reinstall the Dishwasher – Once you’re satisfied that the new drain pump is working correctly, slide the dishwasher back under the countertop. Reconnect the water supply and plug in the dishwasher. Turn on the power and run a full cycle to ensure everything is working as it should be.
In conclusion, replacing a dishwasher drain pump is a straightforward process if you follow these steps.
If you’re not comfortable working with electrical appliances, it’s best to call a professional. However, if you’re up for the task, this is a great DIY project that can save you money in the long run.
For all your Dishwasher Repair needs, you can find the right Dishwasher Spares at Whitegoods Help.
